DF Leonardo Chip Arduino, Arduino Compatible

DF Leonardo Chip Arduino, Arduino Compatible Pinout Mapping, 8 PI GPIO Raspberry Standard 3pin Sensor pinHhead, SPI Extended Raspberry PI, I2C and UART port, Vehicle Control Atmega32u4...

  Cloud Rack    

Cloud Rack Arduino Espansione Scudo per Lampone Pi B + (Compatibile con Ipd 2 Modello B) Open Source DIY Onboard Microcontroller: ATmega32u4 Arduino Leonardo Chip Arduino Compatible pin mapping Compatible with All arduino standard shield and sensors System Voltage: 5v...

  Xcsource    

Leonardo R3 Pro Micro ATmega32U4 Board Arduino Compatible IDE + USB cavo TE169...

ARDUINO LEONARDO ETH, WITH POE A000023 By ARDUINO...

OLIMEXINO-32U4 Arduino Leonardo compatibile...

  Hailege    

Hailege PCA9685 Servo Shield PCA9685 16 Channel 12-bit PWM Servo Driver Shield I2C Interface for Arduino Instead of using a latch and the for Arduino's PWM pins, we have a fully-dedicated PWM driver chip onboard. PCA9685 Servo Shield PCA9685 16 Channel 12-bit PWM Servo Driver Shield I2C Interface. Compatible with Arduino...

  Hiletgo    

HiLetgo PCA9685 Servo Shield PCA9685 16 Channel 12-Bit PWM Servo Driver Shield I2C Interface for Arduino PCA9685 Servo Shield PCA9685 16 Channel 12-bit PWM Servo Driver Shield I2C Interface. Instead of using a latch and the for Arduino's PWM pins, we have a fully-dedicated PWM driver chip onboard. Compatible with Arduino...

ESP8266 Wifi Bee (Arduino Compatible), Applicable to Various 3.3V Single-Chip System. Support XBEE Slot, AP+STA Mode CO-Exist, UART Interface, TTL Serial Port to Wireless Application.

  Ziyun    

ZIYUN W5500 Ethernet With POE Control Board(Arduino Compatible) - Uses A High-Efficiency Spi Protocol, Which Supports 80 Mhz Speed For The High Speed Network Communication W5500 Ethernet with POE Mainboard is based on the ATmega32u4 and W5500 Ethernet chip, which is quite useful to most IOT projects. W5500 chip is a Hardwired...

  Aptofun    

AptoFun NFC/RFID Reader/Writer PN532 für Arduino/Development Boards Module V 2.0 This NFC/RFID breakout base on PN532, which is the most popular NFC chip, and is what is embedded in pretty much every phone or device that does NFC. It can pretty much do it all, such as read and write to tags and cards, communicate with phones...

  Seeedstudio    

Seeedstudio base Shield V2/Power COMPATIBLE: Every Grove Connector Has Four Wires, One of Which is VCC. however, not Every Micro Controller di Main Board Needs A SUPPLY Voltage of 5 V, Some Need 3.3 V. That' s Why We Add a Power Switch to base Shield V2 Così while using Arduino Uno with base Shield V2, please Turn The Switch...

300    

MEGA 2560 PRO Board Embed CH340G/ATMEGA2560-16AU Chip with Male pin headers, Compatible for arduino Mega2560 DIY...

  Ziyun    

ZIYUN - DFRobot Leonardo With Xbee Socket (An Arduino Leonardo Variant Processor) DFRobot Leonardo with Xbee socket is an Arduino Leonardo variant processor. The Arduino Leonardo is based on the ATmega32u4 chip. Based on the Arduino official Leonardo processor,this one from DFRobot equips an xbee socket and 3 sensor extension...

Arduino Leonardo Descrizione del prodotto: Arduino Leonardo Tipo di interfaccia: USB Frequenza del processore: 16 MHz...

300    

Arduino ATmega2560-16U-TW R3 Compatible Board...

300    

LilyPad ATmega328P Arduino Compatible Development Board...

  Freenove    

Freenove Raspberry Pi Pico (Compatible with Arduino IDE) Pre-Soldered Header, Development Board, Python C Java Code, Detailed Tutorial, Example Projects Raspberry Pi Pico -> Official board with Pre-Soldered Header. Come with pinout card and stickers. 3 tutorials with MicroPython, C and Processing (Java) code -> The download...

  Hiletgo    

HiLetgo 3pcs Leonardo Pro Micro ATmega32U4 5V/16MHz Bootloader Micro USB Leonardo Pro Micro for Arduino Compatible ATmega32U4 running at 5V/16MHz Supported by Arduino IDE v1.0.1 On-Board Micro-USB connector for programming 4 x 10-bit ADC pins, 12 x Digital I/Os Rx and Tx Hardware Serial Connections...

  Hailege    

Hailege 2pcs Leonardo Pro Micro ATmega32U4 5V/16MHz Bootloader Micro USB Leonardo Pro Micro for Arduino Compatible Supported by Arduino IDE v1.0.1 ATmega32U4 running at 5V/16MHz On-Board Micro-USB connector for programming Rx and Tx Hardware Serial Connections...

Impilabile maschio a femmina Header di espansione per Arduino Uno r3 e compatibili Evolution Boards, Leonardo, Stackable passo 2.4 mm Male to Female Pin intestazioni collettori Female to Male pin to be used for Arduino and compatible Development Boards Da donna a uomo Pin intestazioni utilizzate per Arduino e compatibile...

Mapping (Original)...

Mind Mapping...

Self Mapping...

300    

100% NEW Original 5PCS HT1622 Chip RAM Mapping 32x8 LCD Controller for I/O IC QFP64...

  Cqrobot    

Can Bus Transceiver Module, Pin Compatible with PCA82C250, 3.3V Power Supply, with ESD Protection, Original SN65HVD230 Chip Onboard, Accessory Board Used for Connecting MCUs to The Can Network. Accessory board used for connecting MCUs to the CAN network, 3.3V, ESD protection. The SN65HVD230 CAN Board is an accessory board...

  Hailege    

Hailege 3.5 inch IPS TFT LCD Display ILI9486/ILI9488 480x320 36 Pins for Arduino MEGA Support Arduino MEGA Directly inserted 3.5" IPS TFT LCD Display ILI9486/ILI9488 480x320 With Full-angle IPS TFT panel; onBorad level conversion chip for 5V/3.3V MCU Compatible with Arduino-Series development Board. (Please notice:This...

  Best Price Square    

Best Price Square ARDUINO Leonardo ETH, Without Poe BPSCA A000022 - SC13828 di ARDUINO ARDUINO LEONARDO ETH, WITHOUT POE BPSCA A000022 - SC13828 Di ARDUINO Manufacturer Name: ARDUINO Manufacture Part No: BPSCP A000022 - SC13828 IT...

  Ziyun    

Papilio Duo-2Mb Spartan 6 LX9 FPGA Dual Channel FTDI FT2232H USB 2.0 Interface Atmel AVR ATmega32U4 - Arduino-Compatible Chip 54 I/O pins arranged in an Arduino-Compatible Mega Form Factor Digital Pins 0-16 Connected to FPGA and ATmega32U4...

300    

Replaced Chip For Arduino NANO V3.0 HT42B534 Chip LGT8F328P LQFP32 MiniEVB...

  Kyyka    

Scheda MEGA R3 con cavo USB, KYYKA Mega R3 Microcontroller Board Compatibile con Arduino IDE Projects RoHS(blu) Il Mega è compatibile al 100% con Arduino IDE e la maggior parte degli schermi progettati per Arduino mega R3, RoHS Compliant Utilizzare lo stesso chip come l'originale Atmega, stesso con la versione ufficiale...

300    

For SHARP AL2041 compatible chip...

  Adafruit    

FLORA - Wearable Electronic Platform (Arduino Compatible)...

  Dfrobot    

DFRobot Proto Screw Shield-Assembled (Arduino Compatible) DFRobot SKU: DFR0131...

300    

Digispark ATTINY85 USB Development Board - Arduino Compatible...

300    

Arduino LilyPad ATmega32U4 Development Board - Compatible...

300    

AiSpark FireBeetle Board ESP32-E (Arduino Compatible)...

  Waveshare    

4inch Arduino Display Module Resistive Touch Screen TFT LCD Shield 480x320 SPI Interface Compatible with Arduino Uno/Leonardo/Uno Plus STM32 Nucleo/XNUCLEO Resistive touch screen TFT LCD, 4inch, 480x320 resolution Standard Arduino interface, compatible with development boards like: Arduino UNO, Leonardo, UNO PLUS, NUCLEO...

300    

Kit for HuaDuino - Arduino Compatible Board with Lithium Battery Power Up and Charging...

300    

Compatible with Arduino UNO upgrade expansion board PS2x/NRF24L01 interface SensorV6.2...

300    

UNO R3 Board for Arduino Compatible + CNC V3 Shield + 4x DRV8825 Driver...